I completed this on Apple Tree about five years ago ... memory is a bit foggy but I think you can do it with two sheets. You need to "spline" the section by the galley to get the correct width as it is over 4 feet wide there. I first did a rough cut (within say a half inch) with a jig saw, then used a router with the original boards as the guide and got a real close fit. I also go rid of some goofy small bits of floor boards. The main salon area is now two large pieces with two "hatches" to get into the bilge. One piece for the gallery area, one piece for the small area by the head, and finally a small one in the v-berth. I also went with cup washers around the perimter.
Bruce S/V Apple Tree 35-3 ----- Original Message ----- From: "Indigo" <ind...@thethomsons.us> To: cnc-list@cnc-list.com Sent: Thursday, October 4, 2012 2:37:44 PM Subject: Stus-List Teak and Holly for C&C 35MKIII I am getting mentally prepared to tackle replacement of the cabin sole on Indigo. Can anyone with a 35MKIII that has done this, please advise how many sheets of 8’ x 4’ I will need so that the holly lines will line up? Jonathan Indigo C&C35MKIII _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
