Scott Oertel wrote:
Dennis Peterson wrote:
Odhiambo Washington wrote:
* On 20/02/07 16:25 -0500, Kevin Way wrote:
| Dennis Peterson wrote:
| >> So, its been a few days. How is everyone feeling about the new
version?
| >> I've hesitated to upgrade just yet. I've seen alot of feedback
indicating
| >> problems and very little about smooth and great upgrades.
| >>
| >> What's the general concensous - You can't upgrade fast enough
or Stay where
| >> you are?
| >>
| >>
| >> | >
| > I just had to back it out of production. It would not run more
than a couple
| > minutes under a normal load that 88.7 shrugs off. It dies
without any error
| > messages.
| > | | Same here. Tried to roll it into production in an
exim/clamav setup. | Had to back it out because it just got slower,
and slower and then it
| stopped. No errors, just no more action.
Hi Dennis,
Have you considered upgrading again?
I tested 0.90 on two very busy servers (Exim/Clamav) and had to back
off
to 0.88.7 because of same reasons....
I simply could not figure out why it could not perform as 0.88.7.
I am waiting until we have 0.90.1 in the FreeBSD ports tree before I
can sit down and try once more.
I am running 0.90.1 without the experimental code enabled, and it is
doing very well. On five production servers the memory footprint and
performance are improved over 88.7, and there have been no forced
restarts.
dp
_______________________________________________
Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net
http://lurker.clamav.net/list/clamav-users.html
I also rolled out 0.90 into production, it ran fine for a few hours
then I noticed heavy IO load coming from clamav, so much infact it
affected the entire performance of the server, before it just stopped
working. I compiled it without experimental code enabled, but I had to
back it out. I noticed in the ports there is 0.90_3, maybe ill give it
a shot today on a secondary filter or something.
-SO
_______________________________________________
Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net
http://lurker.clamav.net/list/clamav-users.html
Just installed the 0.90_3 port, same problem, except it took a little
bit less time for the IO to get real high, for some reason clam just
can't keep up. I guess I'll wait until the next version hits the ports
tree and try again.
-SO
_______________________________________________
Help us build a comprehensive ClamAV guide: visit http://wiki.clamav.net
http://lurker.clamav.net/list/clamav-users.html