Just downloaded v0.60, already running 0.24. I run ClamAV on a lower spec. machine which has no GCC on it, so I compile on another machine. I've done this in the past where I compile on one machine, copy over to the other and then do a make install without issue. However, can't get this to work with 0.60 as it insists on trying to compile again.
The machine I compile on is i686-pc-linux-gnu and I wish to run on a i586-pc-linux-gnuoldld. I tried doing a ./configure --build=i586-pc-linux-gnuoldld on the i686 machine, but this still didn't work, so I also tried ./configure --target=i586-pc-linux-gnuoldld, and that also failed.
I'm sure the answer is simple, but I'm not too hot on Makefiles, etc., is there a solution to this ?
Thanks
Andy
------------------------------------------------------- This SF.Net email sponsored by: Free pre-built ASP.NET sites including Data Reports, E-commerce, Portals, and Forums are available now. Download today and enter to win an XBOX or Visual Studio .NET. http://aspnet.click-url.com/go/psa00100003ave/direct;at.aspnet_072303_01/01 _______________________________________________ Clamav-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/clamav-users
