Hi Rob, Please have a look at Niclas blog post about the NCS5500, it should answer your question: https://xrdocs.io/cloud-scale-networking/tutorials/ncs5500-fib-programming-speed/
Best Regards Ted Sent while walking On 5 Oct 2018, at 09:18, Robert Hass <[email protected]<mailto:[email protected]>> wrote: Hi I'm looking for share experiences regarding time needed to program full DFZ table (710K IPv4 prefixes) on NCS 5500 boxes. Right now we testing competitors (Jericho based boxes) and results are not impressive - time needed to program is aroud 2min 30sec up to 3min. How fast NCS 5500 is handing FIB programming ? Rob _______________________________________________ cisco-nsp mailing list [email protected]<mailto:[email protected]> https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ ******** IMPORTANT NOTICE ******** The content of this e-mail is intended for the addressee(s) only and may contain information that is confidential and/or otherwise protected from disclosure. If you are not the intended recipient, please note that any copying, distribution or any other use or dissemination of the information contained in this e-mail (and its attachments) is strictly prohibited. If you have received this e-mail in error, kindly notify the sender immediately by replying to this e-mail and delete the e-mail and any copies thereof. Tele2 AB (publ) and its subsidiaries (“Tele2 Group”) accepts no responsibility for the consequences of any viruses, corruption or other interference transmitted by e-mail. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
