Good,
thnks every one for yours answers, I try to run UDLD protocol but, the
2 router that I got, one is a cisco ASR 9k and the other one is HUAWEI,
the HUAWEI one doesnt have have this protocolo (UDLD),...¿ what standard
protocolo must I run, well, I mean what protocolo can replace UDLD in
HUAWEI router ??
I also configured boudle interfaces in active mode, but I still got the
same behavior...
El 10/04/14 17:11, Nick Hilliard escribió:
On 10/04/2014 21:11, Alejandro Aristizabal wrote:
I got an interface Bundle with 2 memebers, interfaces Gi0/0/0/18 and
Gi0/0/0/19 (each one has two fiber cords, rx and tx), one fiber cord (tx)
got damaged on interface Gi0/0/0/19 but this interface was still in UP UP
state, the bundle still used this interface for traffic sending. ¿if one
cord got damaged why the interface was still in UP UP state... How can I
make if this happen again, the interface Gi0/0/0/19 goes down ?
sounds like XR on asr9k. If this is correct and you're running ip on the
bundle interface, you may also want to consider bfd on the bundle member links:
http://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r4-3/routing/configuration/guide/b_routing_cg43xasr9k/b_routing_cg43xasr9k_chapter_011.html#d115799e3688a1635
Nick
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
--
Alejandro Aristizabal
Analista de Interconexión
Email: [email protected]
Móvil: 3206777514
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
