Hi, Sounds like Unidirectional Link Detection Protocol (UDLD) could be something for you to check out. Here's a prey good explanation of how it works: http://packetlife.net/blog/2011/mar/7/udld/
Regards, /Ulrik Ivers -----Original Message----- From: cisco-nsp [mailto:[email protected]] On Behalf Of Alejandro Aristizabal Sent: den 10 april 2014 22:12 To: [email protected] Subject: [c-nsp] Bundle member issue Good, I got an interface Bundle with 2 memebers, interfaces Gi0/0/0/18 and Gi0/0/0/19 (each one has two fiber cords, rx and tx), one fiber cord (tx) got damaged on interface Gi0/0/0/19 but this interface was still in UP UP state, the bundle still used this interface for traffic sending. ¿if one cord got damaged why the interface was still in UP UP state... How can I make if this happen again, the interface Gi0/0/0/19 goes down ? thanks for read this message, and Id like some one help me solving this issue. -- Alejandro Aristizabal Analista de Interconexión Email: [email protected] Móvil: 3206777514 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
