It also could be the version of SW doesn't support this particular pluggable. Go poke around on Cisco's site to check.
--chip On Mon, May 23, 2011 at 4:29 PM, David Prall <[email protected]> wrote: > It is "service unsupported-transceiver" it is hidden so tab completion won't > help you. > > cat3560-1(config)#service unsupported-transceiver > Warning: When Cisco determines that a fault or defect can be traced to > the use of third-party transceivers installed by a customer or reseller, > then, at Cisco's discretion, Cisco may withhold support under warranty or > a Cisco support program. In the course of providing support for a Cisco > networking product Cisco may require that the end user install Cisco > transceivers if Cisco determines that removing third-party parts will > assist Cisco in diagnosing the cause of a support issue. > > cat3560-1(config)#no service unsupported-transceiver > > David > > -- > http://dcp.dcptech.com > > >> -----Original Message----- >> From: [email protected] [mailto:cisco-nsp- >> [email protected]] On Behalf Of Dennis >> Sent: Monday, May 23, 2011 4:15 PM >> To: [email protected] >> Subject: [c-nsp] Fwd: GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification >> check failed for GBIC in port [dec] >> >> I'm out of my element at this point - does anyone else have any >> suggestions? >> >> >> ---------- Forwarded message ---------- >> From: Farooq Razzaque <[email protected]> >> Date: Mon, May 23, 2011 at 1:05 PM >> Subject: RE: [c-nsp] GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification >> check failed for GBIC in port [dec] >> To: [email protected] >> >> >> Dear Dennis >> >> I tried the following command but this command is not support. can u >> please check again and let me know >> >> service-unsupported transceiver >> >> >> >> >> >> >> >> >> >> >> > Date: Mon, 23 May 2011 09:31:58 -0700 >> > Subject: Re: [c-nsp] GBIC_SECURITY_CRYPT-4-ID_MISMATCH: >> Identification check failed for GBIC in port [dec] >> > From: [email protected] >> > To: [email protected] >> > >> > On Mon, May 23, 2011 at 9:30 AM, Farooq Razzaque >> <[email protected]> wrote: >> > > Dear Dennis >> > > >> > > Is there need to upgrade the IOS ? >> > >> > I don't know for sure. Are you using Cisco SFPs? What IOS is it? >> > >> > >> > > >> > > service-unsupported transceiver >> > > >> > > Do i need to put the following commands as well or only the above >> command >> > > will be sufficient. >> > >> > Just try the above if that doesn't work put in the below commands as >> well. >> > >> > > >> > > no errdisable detect cause gbic-invalid >> > > errdisable recovery cause all >> > > errdisable recovery interval 30 >> > > >> > >> > Thanks, >> > >> > Dennis O. >> > > >> > > >> > > >> > > >> > > >> > > >> > > >> > > >> > > >> > > >> > >> Date: Mon, 23 May 2011 09:27:51 -0700 >> > >> Subject: Re: [c-nsp] GBIC_SECURITY_CRYPT-4-ID_MISMATCH: >> Identification >> > >> check failed for GBIC in port [dec] >> > >> From: [email protected] >> > >> To: [email protected] >> > >> >> > >> On Mon, May 23, 2011 at 9:26 AM, Farooq Razzaque >> <[email protected]> >> > >> wrote: >> > >> > Dear Dannis >> > >> > >> > >> > Thanks for your reply >> > >> > >> > >> > Is there any need to upgrade the IOS ? >> > >> > >> > >> > Are the following commands will be put on the GBIC interface >> > >> >> > >> Just do it in global config mode. >> > > >> >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- Just my $.02, your mileage may vary, batteries not included, etc.... _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
