Hello community,
I received a 7204VXR chassis with a I/O controler (no FE ports on
it) et
plugged in it an old NPE-400 plus 2 PA-FE.
PA-FE 1 in in slot 1.
PA-FE 2 is in slot 2.
Upgraded my bootloader with c7200-boot-mz.120-22.S.bin and my
version of
IOS
is c7200-adventerprisek9-mz.122-33.SRD.bin.
Here is my problem :
When PA-FE1 is in slot1, the router loops during boot and the
following
appears :
*Mar 8 05:20:09.459: %SYS-5-RELOAD: Reload requested by console.
Reload
Reason: Reload command.
System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2002 by cisco Systems, Inc.
C7200 platform with 524288 Kbytes of main memory
Self decompressing the image :
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
#################################################################]
%SYS-4-CONFIG_NEWER: Configuration from version 12.2 may not be
correctly
understood
%DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
%DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
%DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem?
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot
loader.
Self decompressing the image :
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
###
#################################################################]
System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2002 by cisco Systems, Inc.
*ROM: Rebooted by watchdog hard reset
*C7200 platform with 524288 Kbytes of main memory
When I remove the PA-FE from slot 1 or insert it in another slot
(2,3 or
4),
everything works like a charm. Moreover, swapping with another PA-
FE in
slot1 causes the same problem !?!
Here is a sh controller of the PA-FE in question (but inserted in
slot 3)
:
Interface FastEthernet3/0
Hardware is DEC21140
dec21140_ds=0x65948454, registers=0x3D800000, ib=0xE179D40
rx ring entries=128, tx ring entries=256, af setup failed=0
rxring=0x7E179E40, rxr shadow=0x65948A38, rx_head=0, rx_tail=0
txring=0x7E17A680, txr shadow=0x65948C6C, tx_head=2, tx_tail=2,
tx_count=0
PHY link up
CSR0=0xFFFA9082, CSR3=0xE179E40, CSR4=0xE17A680, CSR5=0xFC000000
CSR6=0xE0000000, CSR7=0xFFFE0000, CSR8=0xFFFE0000, CSR9=0xFFFDD7FF
CSR11=0xFFFE0000, CSR12=0xFFFFFF09, CSR15=0xFFFFFEC8
TX state: stopped
RX state: stopped - RESET or STOP RECEIVE command
Far End Fault Indication (For FX Interface): OFF
DEC21140 PCI registers:
bus_no=6, device_no=0
CFID=0x00091011, CFCS=0x02800006, CFRV=0x02000012, CFLT=0x0000FF00
CBIO=0xDFEFFF81, CBMA=0x49000000, CFIT=0x000001D1, CFDA=0x0000EF00
MII registers:
Register 0x00: 0400 784B 2000 5C01 0081 0000 0000 0000
Register 0x08: 0000 0000 0000 0000 0000 0000 0000 0000
Register 0x10: 0000 0000 0000 0000 0000 0001 8060
Register 0x18: 8020 0800 0000 3800 A3B9
Software MAC address filter(hash:length/addr/mask/hits):
need_af_check = 0
0x00: 0 ffff.ffff.ffff 0000.0000.0000 0
0x10: 0 0009.443e.8854 0000.0000.0000 0
throttled=0, enabled=0, disabled=0
rx_fifo_overflow=0, rx_no_enp=0, rx_state=0
tx_underrun_err=0, tx_jabber_timeout=0, tx_carrier_loss=1
tx_no_carrier=0, tx_late_collision=0, tx_excess_coll=0
tx_collision_cnt=0, tx_deferred=0, fatal_tx_err=0, tbl_overflow=0
rx_pak_len_err = 0, filtered_pak_cnt = 0
tx_limited=0(256)
HW addr filter: 0xE18E700, ISL Disabled
Entry= 0: Addr=FFFF.FFFF.FFFF
Entry= 1: Addr=FFFF.FFFF.FFFF
Entry= 2: Addr=FFFF.FFFF.FFFF
Entry= 3: Addr=FFFF.FFFF.FFFF
Entry= 4: Addr=FFFF.FFFF.FFFF
Entry= 5: Addr=FFFF.FFFF.FFFF
Entry= 6: Addr=FFFF.FFFF.FFFF
Entry= 7: Addr=FFFF.FFFF.FFFF
Entry= 8: Addr=FFFF.FFFF.FFFF
Entry= 9: Addr=FFFF.FFFF.FFFF
Entry=10: Addr=FFFF.FFFF.FFFF
Entry=11: Addr=FFFF.FFFF.FFFF
Entry=12: Addr=FFFF.FFFF.FFFF
Entry=13: Addr=FFFF.FFFF.FFFF
Entry=14: Addr=FFFF.FFFF.FFFF
Entry=15: Addr=0009.443E.8854
I have been googling around but nothing very concluant so far.
Any clues ?
Thanks.
Best regards.
Cheers,
--
Youssef BENGELLOUN-ZAHR ……………………………………
…………
Ingénieur Réseaux et Télécoms
Technopole de l'Aube en Champagne - BP 601 - 10901 TROYES Cedex 9
Agence Paris : 6, rue Charles Floquet - 92120 MONTROUGE
Tel +33 (0) 825 000 720
Tel. direct +33 (0) 1 77 35 59 14
Tel. portable +33 (0) 6 22 42 63 80
Email [email protected]
…
…
…
…
…
…
…
…
…
…
…
………………………………………………….....www.72
0.fr
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
