Hello Philip, By default, the router boots with all its PA-FEs in shut down state.
I have tried to reboot several time (in shut down state), always the same. Y. 2010/3/8 Philip Davis <[email protected]> > What happens if you boot with F1/0 configured for a shutdown state? > > On 3/8/2010 10:42 AM, Youssef Bengelloun-Zahr wrote: > > Hello community, > > > > I received a 7204VXR chassis with a I/O controler (no FE ports on it) et > > plugged in it an old NPE-400 plus 2 PA-FE. > > > > PA-FE 1 in in slot 1. > > > > PA-FE 2 is in slot 2. > > > > Upgraded my bootloader with c7200-boot-mz.120-22.S.bin and my version of > IOS > > is c7200-adventerprisek9-mz.122-33.SRD.bin. > > > > Here is my problem : > > > > When PA-FE1 is in slot1, the router loops during boot and the following > > appears : > > > > *Mar 8 05:20:09.459: %SYS-5-RELOAD: Reload requested by console. Reload > > Reason: Reload command. > > System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1) > > TAC Support: http://www.cisco.com/tac > > Copyright (c) 2002 by cisco Systems, Inc. > > C7200 platform with 524288 Kbytes of main memory > > > > > > Self decompressing the image : > > > ###########################################################################################################################################################################################################] > > > > %SYS-4-CONFIG_NEWER: Configuration from version 12.2 may not be correctly > > understood > > %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem? > > %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem? > > %DEC21140-5-NOCARR: FastEthernet1/0 cable/connector problem? > > %SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader. > > Self decompressing the image : > > > ###########################################################################################################################################################################################################] > > > > System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1) > > TAC Support: http://www.cisco.com/tac > > Copyright (c) 2002 by cisco Systems, Inc. > > > > *ROM: Rebooted by watchdog hard reset > > *C7200 platform with 524288 Kbytes of main memory > > > > > > When I remove the PA-FE from slot 1 or insert it in another slot (2,3 or > 4), > > everything works like a charm. Moreover, swapping with another PA-FE in > > slot1 causes the same problem !?! > > > > Here is a sh controller of the PA-FE in question (but inserted in slot 3) > : > > > > Interface FastEthernet3/0 > > Hardware is DEC21140 > > dec21140_ds=0x65948454, registers=0x3D800000, ib=0xE179D40 > > rx ring entries=128, tx ring entries=256, af setup failed=0 > > rxring=0x7E179E40, rxr shadow=0x65948A38, rx_head=0, rx_tail=0 > > txring=0x7E17A680, txr shadow=0x65948C6C, tx_head=2, tx_tail=2, > tx_count=0 > > PHY link up > > CSR0=0xFFFA9082, CSR3=0xE179E40, CSR4=0xE17A680, CSR5=0xFC000000 > > CSR6=0xE0000000, CSR7=0xFFFE0000, CSR8=0xFFFE0000, CSR9=0xFFFDD7FF > > CSR11=0xFFFE0000, CSR12=0xFFFFFF09, CSR15=0xFFFFFEC8 > > TX state: stopped > > RX state: stopped - RESET or STOP RECEIVE command > > Far End Fault Indication (For FX Interface): OFF > > DEC21140 PCI registers: > > bus_no=6, device_no=0 > > CFID=0x00091011, CFCS=0x02800006, CFRV=0x02000012, CFLT=0x0000FF00 > > CBIO=0xDFEFFF81, CBMA=0x49000000, CFIT=0x000001D1, CFDA=0x0000EF00 > > MII registers: > > Register 0x00: 0400 784B 2000 5C01 0081 0000 0000 0000 > > Register 0x08: 0000 0000 0000 0000 0000 0000 0000 0000 > > Register 0x10: 0000 0000 0000 0000 0000 0001 8060 > > Register 0x18: 8020 0800 0000 3800 A3B9 > > Software MAC address filter(hash:length/addr/mask/hits): > > need_af_check = 0 > > 0x00: 0 ffff.ffff.ffff 0000.0000.0000 0 > > 0x10: 0 0009.443e.8854 0000.0000.0000 0 > > throttled=0, enabled=0, disabled=0 > > rx_fifo_overflow=0, rx_no_enp=0, rx_state=0 > > tx_underrun_err=0, tx_jabber_timeout=0, tx_carrier_loss=1 > > tx_no_carrier=0, tx_late_collision=0, tx_excess_coll=0 > > tx_collision_cnt=0, tx_deferred=0, fatal_tx_err=0, tbl_overflow=0 > > rx_pak_len_err = 0, filtered_pak_cnt = 0 > > tx_limited=0(256) > > HW addr filter: 0xE18E700, ISL Disabled > > Entry= 0: Addr=FFFF.FFFF.FFFF > > Entry= 1: Addr=FFFF.FFFF.FFFF > > Entry= 2: Addr=FFFF.FFFF.FFFF > > Entry= 3: Addr=FFFF.FFFF.FFFF > > Entry= 4: Addr=FFFF.FFFF.FFFF > > Entry= 5: Addr=FFFF.FFFF.FFFF > > Entry= 6: Addr=FFFF.FFFF.FFFF > > Entry= 7: Addr=FFFF.FFFF.FFFF > > Entry= 8: Addr=FFFF.FFFF.FFFF > > Entry= 9: Addr=FFFF.FFFF.FFFF > > Entry=10: Addr=FFFF.FFFF.FFFF > > Entry=11: Addr=FFFF.FFFF.FFFF > > Entry=12: Addr=FFFF.FFFF.FFFF > > Entry=13: Addr=FFFF.FFFF.FFFF > > Entry=14: Addr=FFFF.FFFF.FFFF > > Entry=15: Addr=0009.443E.8854 > > > > I have been googling around but nothing very concluant so far. > > > > Any clues ? > > > > Thanks. > > > > Best regards. > > > > Cheers, > > > > > -- > > Philip Davis > Systems Administrator > I-2000 Inc. > (616) 532-8425 > 888-234-4254 > -- Youssef BENGELLOUN-ZAHR ……………………………………………… Ingénieur Réseaux et Télécoms Technopole de l'Aube en Champagne - BP 601 - 10901 TROYES Cedex 9 Agence Paris : 6, rue Charles Floquet - 92120 MONTROUGE Tel +33 (0) 825 000 720 Tel. direct +33 (0) 1 77 35 59 14 Tel. portable +33 (0) 6 22 42 63 80 Email [email protected] ……………………………………………………………………………….....www.720.fr _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
