This doesn't actually clear completely the pseudowire. It surely kills it (i can see it
going down), but something is kept "online" (like a cache), because in my case (SRD2/SRD3)
the remote description doesn't get updated after doing shut/no shut on both sides. Maybe
that's a bug and it's not supposed to happen, but unless i remove the xconnect xonfig and
re-add it, the remote description doesn't get updated in any other case.
It's strange that something in the lines of "clear mpls l2 vc" doesn't exist :(
--
Tassos
Marko Milivojevic wrote on 29/11/2009 13:43:
On Fri, Nov 27, 2009 at 08:15, Tassos Chatzithomaoglou
<[email protected]> wrote:
Is there an easy way to clear/reset a eompls pseudowire?
The only (not affecting other services of the same interface) way i have
found is to remove the xconnect config from both sides, but i was hoping
that a clear command would exist.
Can't you simply shut down the subinterface where xconnect is configured?
--
Marko Milivojevic - CCIE #18427
Senior Technical Instructor - IPexpert
Mailto: [email protected]
Telephone: +1.810.326.1444
Live Assistance, Please visit: http://www.ipexpert.com/chat
eFax: +1.810.454.0130
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
