Yes, it would. I guess for finer granularity you can only, and un-elegantly, screw the circuit up by playing with the VC MTU, at one side of it.
Cheers, Paolo On Fri, Nov 27, 2009 at 08:05:50PM +0200, Tassos Chatzithomaoglou wrote: > That would kill all pseudowires with the same neighbor, wouldn't it? > > > -- > Tassos > > > Paolo Lucente wrote on 27/11/2009 11:52: >> Hi Tassos, >> >> As signalling is done via targeted LDP, perhaps you want to achieve that >> by clearing the specific LDP neighbor? >> >> Cheers, >> Paolo >> >> On Fri, Nov 27, 2009 at 10:15:27AM +0200, Tassos Chatzithomaoglou wrote: >>> Is there an easy way to clear/reset a eompls pseudowire? >>> >>> The only (not affecting other services of the same interface) way i >>> have found is to remove the xconnect config from both sides, but i >>> was hoping that a clear command would exist. >>> >>> -- >>> Tassos >> >> > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
