That would kill all pseudowires with the same neighbor, wouldn't it?
--
Tassos
Paolo Lucente wrote on 27/11/2009 11:52:
Hi Tassos,
As signalling is done via targeted LDP, perhaps you want to achieve that
by clearing the specific LDP neighbor?
Cheers,
Paolo
On Fri, Nov 27, 2009 at 10:15:27AM +0200, Tassos Chatzithomaoglou wrote:
Is there an easy way to clear/reset a eompls pseudowire?
The only (not affecting other services of the same interface) way i have
found is to remove the xconnect config from both sides, but i was hoping
that a clear command would exist.
--
Tassos
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
