On Fri, 23 Oct 2015, Aaron Wood wrote:
On Fri, Oct 23, 2015 at 9:10 AM, Richard Smith <smithb...@gmail.com> wrote:
I have a shiny new Linksys WRT1900ACS to test.
I thought it might be nice to start with some comparisons of factory
firmware vs OpenWRT with sqm enabled.
Here are my results with the same router (unless the WRT1900ACS is
different from the WRT1900AC):
http://burntchrome.blogspot.com/2015/06/sqmscripts-before-and-after-at-160mbps.html
the ACS has more flash (and ram IIRC) and is 1.6GHz instead of 1.2GHz
David Lang
So I built and installed an openwrt trunk but the results were very
non-impressive. Rrul test reported mulit-seconds of latency and it was
equally non-impressive with sqm enabled or disabled. So I assumed that sqm
in trunk on this device must not work yet. Then I wondered how well sqm in
trunk was tested and that perhaps its broken for all devices.
Trunk or the Chaos Calmer release? (I"m running CC RC1)
My test setup:
Laptop<--1000BaseT-->DUT<--1000baseT-->Server
Which ports on the DUT were you using? are those local ports, or is one of
those the "internet" port?
-Aaron
_______________________________________________
Cerowrt-devel mailing list
Cerowrt-devel@lists.bufferbloat.net
https://lists.bufferbloat.net/listinfo/cerowrt-devel
_______________________________________________
Cerowrt-devel mailing list
Cerowrt-devel@lists.bufferbloat.net
https://lists.bufferbloat.net/listinfo/cerowrt-devel
