On 10/23/2015 01:22 PM, Aaron Wood wrote:
On Fri, Oct 23, 2015 at 9:10 AM, Richard Smith <smithb...@gmail.com
<mailto:smithb...@gmail.com>> wrote:
I have a shiny new Linksys WRT1900ACS to test.
I thought it might be nice to start with some comparisons of factory
firmware vs OpenWRT with sqm enabled.
Here are my results with the same router (unless the WRT1900ACS is
different from the WRT1900AC):
http://burntchrome.blogspot.com/2015/06/sqmscripts-before-and-after-at-160mbps.html
So I built and installed an openwrt trunk but the results were very
non-impressive. Rrul test reported mulit-seconds of latency and it
was equally non-impressive with sqm enabled or disabled. So I
assumed that sqm in trunk on this device must not work yet. Then I
wondered how well sqm in trunk was tested and that perhaps its
broken for all devices.
Trunk or the Chaos Calmer release? (I"m running CC RC1)
If I understand your question correctly I did both. I built trunk (for
both WRT1900ACS and WNDR700v2. Then downloaded the current CC from
openwrt.org and installed sqm.
My test setup:
Which ports on the DUT were you using? are those local ports, or is one
of those the "internet" port?
I was using both WAN & LAN.
Laptop<--1000BaseT-->DUT LAN<-->DUT WAN<--1000baseT-->Server
--
Richard A. Smith
_______________________________________________
Cerowrt-devel mailing list
Cerowrt-devel@lists.bufferbloat.net
https://lists.bufferbloat.net/listinfo/cerowrt-devel
