> From: Fritz Mueller > I'm reassembling an PDP-11/34 in a BA11-K chassis right now, and am a > little puzzled by the front mounting brackets (the ones that hold a > KY11-L of either sort on the bottom, and a half trim-panel on the top). > In particular, on the bottom half, the available place for screws to go > to attach the bracket to the chassis is nearly completely blinded by an > overhanging tab. > .. > Anybody have an 11/34 in a BA11-K and care to take a peek and tell me > how the hardware here is properly configured? Well, I have an KY11-LA mounted on a BA11-K; the KY11-LA and -LB use the same bezel, and should have identical hardware.
There's an intermediate 10" or so high adapter piece (one either side, of course) mounted to the KY11-L. (That's attached to the KY11-L with short machine screws which are inserted from the rear, and go into tapped holes in the KY11-L bezel.) That piece attaches to the BA11-K with different hardware at the top and bottom: on the bottom, a single 1" or so machine screw (#8, I think) goes through the vertical tab on the side at the front of the BA11, to a tapped hole in the adapter piece. At the top, a pair of short countersunk machine screws (#10, I think - definitely larger than the 1" machine screw at the bottom) attach a pair (one each side) of those black plastic mounting widgets which have a pair of balls on stalks; those go into holes on the back of the blank panels, and those screw also hold the adapter piece to the BA11-L at the top. (I looked for the DEC formal name for those pieces, but couldn't find it.) > I'll get some pictures of the brackets I have, too -- maybe they aren't > the standard/correct ones for an 11/34... I'll take a look. I'm too burned out (COVID long haul) at the moment to take pictures or do a drawing right at the moment; if needed, I can do it tomorrow (or so). Noel PS: A while back you were after measurements on the KY11-L power knob; did you ever get those: If not, I've got one, and can measure it.