On 2018-11-07 8:57 PM, Carlos E Murillo-Sanchez via cctalk wrote:
Paul Berger via cctalk wrote:
The AIX on the SP2 would have been the same, in fact the hardware on
the SP2 nodes was similar to the regular RS/6000 boxes except the
console was through a special serial network in the frame and
accessed through the control workstation. Most regular users likely
accessed the nodes through a LAN.
Paul.
So, if I were to hunt for installation media for AIX, which version
would you recommend for a 320H with 32MB of memory, i.e., the latest
that would run and not get too bogged down by that amount of memory?
I can switch to a larger SCSI disk if it need be, but hopefully not
larger than 2GB.
Carlos.
I am no longer sure when support for microchannel was dropped from AIX,
I have always been on the hardware side with limited involvement with
software. Doing a quick look it would seem that it is likely that some
level of version 5 was the last one. Version 6.1 was 64 bit only and
required a POWER4 or later processor.
Paul.
