Hi
1. The complete RX02 with cable and disk (initialized and
system copied /boot to it) boots the 11/73 on an RX02 controller so mode
is correct.
2. The 11/94 boot menu allows you to choose DY0 or DY1 and
both have been tried after moving the floppy of course.
3. As the startup messages appear the disk is being read.
Rod
On 20/09/2017 12:30, Ulrich Tagge via cctalk wrote:
Hi Rod,
I'm sure you are aware about, ... the /94 have a MDM card/module,
where you can set the NPG jumper via switches. Is this set correct for
all the slots, no mismatch in counting the small switches?
Have you checked the flat ribbon cable - I had much fun with damaged
cables?
Have you tried dy0 and dy1?
Is the RX02 set to the correct mode?
The known good 8" disk, is a rx02 disk and not a rx01?
Many Greetings
Ulrich
--
Wanted one pdp-8/i rocker switch leaver to copy.
