It can also ppt out your protein, if it is bound to the DNA. You could also DNase and RNase the bejesus out of it, and temporarily unfold the protein to aid in release of the nucleic acids. Then you need to get rid of these evil enzymes before you put back your nucleic acid of choice.
Pavan wrote: > You could also try polyethyleneimine (Polymin P) precipitation to > precipitate out your DNA. Add Polymin P dropwise to a final > concentration of 0.24% to your cell lysate while stirring in the cold > for an hour. This should precipitate out your DNA. Then centrifuge > your lysate and use the relevant fraction (supernatant or pellet) for > further purification. > > Pavan > > On 7/5/07, Ana Silva <[EMAIL PROTECTED]> wrote: >> Hi, >> >> How much salt do you have in your protein buffer? >> I would try to increase the salt concetration, during purification. >> >> Hope it helps. >> Ana >> >> >> >> [EMAIL PROTECTED] wrote: >> > >> > Dear all, >> > >> > Sorry for the off-topic question. >> > >> > I am purifying a zinc finger transcription factor for crystallization. >> > The protein appeared as a single band on SDS-PAGE (MW 44KD) after NTA >> > chelating column, but its OD280/OD260 ratio is as high as 1.0. So I >> > doubt the protein is nucleic acid contaminated, probably because of >> > the zinc finger. I tried to remove the nucleic acid by Mono Q and >> > Superdex 75 pg, but failed. So could any one recommend some method to >> > remove the nucleic acid during protein crystallization, esp. zinc >> > finger protein? Any experience or references will be appreciated. >> > >> > Thanks a lot! >> > >> > Tiancen Hu >> > >> > Shanghai Institute of Materia Medica >> > >> > >> > >> > ------------------------------------------------------------------------ >> > Ò»Æð À´£¬150 Íò ÈË Í¬ ʱ ÔÚ Íæ µÄ ÃÎ »Ã Î÷ ÓÎ >> > <http://event.mail.163.com/chanel/xyq.htm?from=126_NO4> >> > > > -- > Pavan > http://umsis.miami.edu/~pvaidyan >
