I think there's one or two zeroes extra. Run "sh ip eigrp topology" for that prefix and see the delay. If it's 150, it doesn't matter what syntax you used.
-- Marko Milivojevic - CCIE #18427 (SP R&S) Senior CCIE Instructor - IPexpert :: This message was sent from a mobile device. I apologize for errors and brevity. :: On Nov 6, 2012, at 7:22, Lukasz <[email protected]> wrote: > Hi All, > > > In the above section of the lab it says that R4 loopback should be > redistributed into the eigrp process with delay 150. An example from DSG > shows route-map with seting metric 0 150 255 1 1500. > As we use metric weights 0 0 0 1 0 0 we will only take delay into account > when calculating metric. > > My question...is below solution valid as well? > > route-map LOEIGRP permit 10 > match interfce lo0 > ! > router eigrp 467 > redistribute connected metric 1 150000000 1 1 1 route-map LOEIGRP > > > > > Thanks, > Lukasz > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
