Hi,
I am trying to run OSPF over PPoE but it's not comming up .Here is the server/client config. Tried to change the OSPF network type to point-to-point but still same issue. As per the debug the two ends are complaning about not being on the same subnet and at the same time i can ping othe other side. R4# vpdn enable bba-group pppoe cisco virtual-template 1 username R3 password 0 cisco interface FastEthernet0/0 no ip address duplex auto speed auto pppoe enable group cisco interface Virtual-Template1 ip address 23.23.34.4 255.255.255.0 peer default ip address pool PPoE ppp authentication chap ip local pool PPoE 23.23.34.3 R3# interface FastEthernet0/1 no ip address duplex auto speed auto pppoe enable group cisco pppoe-client dial-pool-number 1 interface Dialer1 ip address negotiated ip mtu 1492 encapsulation ppp dialer pool 1 dialer persistent ppp authentication chap callin ppp chap password 0 cisco R3#debug ip ospf adj OSPF adjacency events debugging is on R3# *Apr 1 17:10:46.111: OSPF: Rcv pkt from 23.23.34.4, Dialer1, area 0.0.0.2 : src not on the same network R3# *Apr 1 17:10:50.242: OSPF: Rcv pkt from 23.23.34.4, Dialer1, area 0.0.0.2 : src not on the same network R3# *Apr 1 17:10:56.111: OSPF: Rcv pkt from 23.23.34.4, Dialer1, area 0.0.0.2 : src not on the same network R3#pi 23.23.34.4 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 23.23.34.4, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms Thanks, _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
