Hi Bill, I will assuming that on your routers the virtual-templates exist on the same subnet.
If you do a show ip route on each of the routers you will see a connected route for the network the virtual-template is associated with and a /32 route for the direct peer through the virtual-access interface Connectivity between spokes occurs via the hub and requires routing and relies on longest match rules and the ppp peer neighbor routes. For spoke to spoke, the spoke will send traffic to the hub, which then will have an exact match for the other spoke due to the ppp neighbor route and be able to select the appropriate virtual-access to reach the other spoke. If you perform a traceroute between spokes even though these are on the same subnet, you will see the hub as a hop to reach the other spoke. Cheers, Adam On Wed, Oct 12, 2011 at 5:39 AM, Bill Riley <[email protected]>wrote: > > > Why is it when I configure the DLCI's using PPP I get a fully meshed > network > and can ping all the spoke sites even though the local DLCI is only setup > to > reach the hub site of R2? > > > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
