I think because some cisco switches can accept only dot1q trunking. That's why
you didn't see the option to choose isl or dot1q.
Regards
Khaled Al-Saholy
> Date: Wed, 12 Jan 2011 18:39:32 +0530
> From: [email protected]
> To: [email protected]
> CC: [email protected]
> Subject: Re: [OSL | CCIE_RS] switchport trunk encap dot1q
>
> Can you show the CLI logs on whats the error that you are getting ?
>
> Thnx
> Gaurav Madan
>
> On Wed, Jan 12, 2011 at 4:45 PM, Ahmed Haji Munye <[email protected]> wrote:
> >
> >
> > Hi
> >
> > I cannot congfigure the command below on a the switches.
> >
> > DLS2(config-if-range)#switchport trunk encap dot1q
> >
> >
> > Please help me out!
> >
> > DLS2(config)#interface range f0/8, f0/12
> > DLS2(config-if-range)#switchport
> > DLS2(config-if-range)#switchport trunk encap dot1q
> > DLS2(config-if-range)#switchport mode trunk
> > DLS2(config-if-range)#no shut
> >
> >
> >
> > _______________________________________________
> > For more information regarding industry leading CCIE Lab training, please
> > visit www.ipexpert.com
> >
> _______________________________________________
> For more information regarding industry leading CCIE Lab training, please
> visit www.ipexpert.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
