The output below doesn't look like the command was rejected but if it was then most likely the switch does not support ISL so dot1Q is the only encapsulation it can use.
On Wed, Jan 12, 2011 at 6:15 AM, Ahmed Haji Munye <[email protected]>wrote: > > > Hi > > I cannot congfigure the command below on a the switches. > > DLS2(config-if-range)#switchport trunk encap dot1q > > > Please help me out! > > DLS2(config)#interface range f0/8, f0/12 > DLS2(config-if-range)#switchport > DLS2(config-if-range)#switchport trunk encap dot1q > DLS2(config-if-range)#switchport mode trunk > DLS2(config-if-range)#no shut > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
