hi ahmed you can do the following command switchport mode dynamic desirable switchport trunk encapsulation dot1q switchport mode trunk end
hope this can help you On Wed, Jan 12, 2011 at 1:15 PM, Ahmed Haji Munye <[email protected]>wrote: > > > Hi > > I cannot congfigure the command below on a the switches. > > DLS2(config-if-range)#switchport trunk encap dot1q > > > Please help me out! > > DLS2(config)#interface range f0/8, f0/12 > DLS2(config-if-range)#switchport > DLS2(config-if-range)#switchport trunk encap dot1q > DLS2(config-if-range)#switchport mode trunk > DLS2(config-if-range)#no shut > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
