Hi Paul, Is this GNS or physical hardware? What about the LSA's from R3? Do they show up in the LSDB on R1? Have you tried clearing the ospf process or removing and reading the OSPF config?
-----Original Message--- From: [email protected] [mailto:[email protected]] On Behalf Of Paul Kim Sent: Sunday, January 09, 2011 11:48 AM To: [email protected] Subject: [OSL | CCIE_RS] OSPF question Hi experts, Probably I have miss-understand some piece of OSPF. Can you please let me know why r1 doesn't adverrise networks defined under ospf statment. r1#sh run | s router ospf router ospf 1 router-id 1.1.1.1 log-adjacency-changes network 43.34.32.1 0.0.0.0 area 0 network 55.55.55.4 0.0.0.0 area 0 network 66.66.66.1 0.0.0.0 area 0 network 172.16.0.1 0.0.0.0 area 0 r1#sh ip int brief | ex una Interface IP-Address OK? Method Status Protocol FastEthernet0/0 3.3.3.1 YES NVRAM up up FastEthernet0/1 55.55.55.4 YES NVRAM up up Serial0/3/0 172.16.0.1 YES NVRAM up up Vlan10 66.66.66.1 YES manual up up Loopback87 43.34.32.1 YES NVRAM up up r1#sh ip ospf nei Neighbor ID Pri State Dead Time Address Interface 3.3.3.3 1 FULL/DR 00:00:30 172.16.0.3 Serial0/3/0 r1#sh ip ospf database self OSPF Router with ID (1.1.1.1) (Process ID 1) Router Link States (Area 0) Link ID ADV Router Age Seq# Checksum Link count 1.1.1.1 1.1.1.1 574 0x80000009 0x00CF89 4 r1# Thanks, Paul _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
