yes r3 is spoke and r5 is hub in frame relay.I attached r4 r5 and r6 config.
On Sun, May 23, 2010 at 10:20 PM, Adrian Brayton <[email protected]> wrote: > If you did the redistribution correctly, it should be in R6s table as an EX > (170) route... Does this involve Frame-Relay? When you redistribute > EIGRP==>OSPF, you are adding the "subnets" keyword and OSPF==>EIGRP adding a > metric? > > Can you please send your configs? > > > > > On May 23, 2010, at 3:12 PM, Mustafa Yadav wrote: > > > hi all > > > > > > r3****ospf***** r5******eigrp****r4*****eigrp*****r6 > > > > > > According to the below diagram I am trying to redistribute r3 loopback > into r6.R5 talks eigrp and ospf as well. in r4 I can see that it has > learned this ip adress via ospf (even it is not shown there is an ospf > connection between r3 and r4).In R4 when I execute sh ip eigrp topology I > see that 0 successors, FD is Inaccessible which is normal since this prefix > is not in the routing table and learned from another protocol.But how can I > put this prefix into r6 router table? > > > > many thanks > > _______________________________________________ > > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > >
r4.rar
Description: Binary data
r5.rar
Description: Binary data
r6.rar
Description: Binary data
r3.rar
Description: Binary data
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
