Hello Dave,
when I first performed the 'add device' option, I only changed the name
for the display and left the rest unchanged. When this didn't workk, I
changed the driver from auto-detect to Freedom Scientific.
This was for the new Focus 40. For the classic Focus 40 I could leave
the driver on auto-connect.
With kind regards,
Henk.
Dave Mielke schreef op 3/4/2014 9:14 PM:
[quoted lines by Henk Abma on 2014/03/04 at 13:36 +0100]
It only took me some time to figure out that auto-detecting the
Freedom Scientific driver didn't work, so I had to set it manually in
the 'add device' part of settings.
What did you do to try to autodetect the device?
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: BRLTTY@mielke.cc
For general information, go to: http://mielke.cc/mailman/listinfo/brltty
