ip addr list:
server:
eth0, lo and
5: tun0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc
pfifo_fast state UNKNOWN qlen 100
link/[65534]
inet 10.29.0.1 peer 10.29.0.2/32 scope global tun0
client:
977: tun0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc
pfifo_fast qlen 100
link/[65534]
inet 10.29.0.6 peer 10.29.0.5/32 scope global tun0
valid_lft forever preferred_lft forever
Following commands resulted in similar output on client and server with
different IP-Addresses.
birdc show interfaces:
tun0 up (index=5)
PtP Multicast AdminUp LinkUp MTU=1500
10.29.0.1/32 (Primary, opposite 10.29.0.2, scope site)
birdc show ospf interface:
BIRD 1.6.3 ready.
myOSPF3:
Interface tun0 (peer 10.29.0.2)
Type: ptp
Area: 0.0.0.0 (0)
State: PtP
Priority: 1
Cost: 10
Hello timer: 10
Wait timer: 10
Dead timer: 40
Retransmit timer: 5
birdc show ospf neighbors: no neighbours.
tcpdump -v -s 0 proto ospf -i tun0
06:59:00.439738 IP (tos 0xc0, ttl 1, id 15270, offset 0, flags [none],
proto OSPF (89), length 64)
server > ospf-all.mcast.net: OSPFv2, Hello, length 44
Router-ID repo.traffic.local, Backbone Area, Authentication Type:
none (0)
Options [External]
Hello Timer 10s, Dead Timer 40s, Mask 0.0.0.0, Priority 1
06:59:02.449363 IP (tos 0xc0, ttl 1, id 18875, offset 0, flags [none],
proto OSPF (89), length 64)
10.29.0.6 > ospf-all.mcast.net: OSPFv2, Hello, length 44
Router-ID 192.168.21.17, Backbone Area, Authentication Type: none
(0)
Options [External]
Hello Timer 10s, Dead Timer 40s, Mask 0.0.0.0, Priority 1
Where server is the name of my server.
In logs I can see only multiple <TRACE> myOSPF3: HELLO packet sent via
tun0 - messages and once after start initial logs like adding area and
originating lsa for routes from static-protocol.
Now i'm trying to establish ptp-connection for ospf, but in future the
server should run in ptmp mode. I suppose, that there is somethnig wrong
with the IP-Address of peer, since the server has IP-Address 10.29.0.1 and
the client 10.29.0.10. But I declared these IP-Adresses as neighbour in
config file. Maybe there is an issue, that the IP-Addresses are in
/32-network? But unfortunately I cannot change anything in openvpn
settings. Do you have any idea, what I'm doing wrong?
2018-03-30 0:25 GMT+02:00 Ondrej Zajicek <santi...@crfreenet.org>:
> On Thu, Mar 29, 2018 at 03:02:52PM +0200, dawid k wrote:
> > Here my configuration (client):
> >
> > ifconfig tun0:
> > tun0 Link encap:UNSPEC HWaddr
> > 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
> > inet addr:10.29.0.10 P-t-P:10.29.0.9 Mask:255.255.255.255
> >
> > bird_ospf.conf (included in bird.conf) :
> >
> > protocol ospf myOSPF {
> > area 0.0.0.0 {
> > interface "tun0" {
> > cost 10;
> > type ptp;
> > stub no; hello 10; transmit delay 5; wait 10;
> dead
> > 40;
> > neighbors {
> > 10.29.0.1;
> > }; }; };
>
> Hi
>
> What do you get from:
>
> ip addr list
> birdc show interfaces
> birdc show ospf interface
> birdc show ospf neighbors
> tcpdump -v -s 0 proto ospf -i tun0
>
>
> Do you have anything interesting in logs?
>
> --
> Elen sila lumenn' omentielvo
>
> Ondrej 'Santiago' Zajicek (email: santi...@crfreenet.org)
> OpenPGP encrypted e-mails preferred (KeyID 0x11DEADC3, wwwkeys.pgp.net)
> "To err is human -- to blame it on a computer is even more so."
>
2018-03-30 0:25 GMT+02:00 Ondrej Zajicek <santi...@crfreenet.org>:
> On Thu, Mar 29, 2018 at 03:02:52PM +0200, dawid k wrote:
> > Here my configuration (client):
> >
> > ifconfig tun0:
> > tun0 Link encap:UNSPEC HWaddr
> > 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
> > inet addr:10.29.0.10 P-t-P:10.29.0.9 Mask:255.255.255.255
> >
> > bird_ospf.conf (included in bird.conf) :
> >
> > protocol ospf myOSPF {
> > area 0.0.0.0 {
> > interface "tun0" {
> > cost 10;
> > type ptp;
> > stub no; hello 10; transmit delay 5; wait 10;
> dead
> > 40;
> > neighbors {
> > 10.29.0.1;
> > }; }; };
>
> Hi
>
> What do you get from:
>
> ip addr list
> birdc show interfaces
> birdc show ospf interface
> birdc show ospf neighbors
> tcpdump -v -s 0 proto ospf -i tun0
>
>
> Do you have anything interesting in logs?
>
> --
> Elen sila lumenn' omentielvo
>
> Ondrej 'Santiago' Zajicek (email: santi...@crfreenet.org)
> OpenPGP encrypted e-mails preferred (KeyID 0x11DEADC3, wwwkeys.pgp.net)
> "To err is human -- to blame it on a computer is even more so."
>
