After successfully installing on an Olinuxino A10 board via the SD card
onto a Toshiba disk with the following MBR partition table, I rebooted
and again offered to perform another OpenBSD installation. Why ?
Thanks in advance for any enlightenment !
-- Patrick
# fdisk sd0
Disk: sd0 geometry: 121601/255/63 [1953525168 Sectors]
Offset: 0 Signature: 0xAA55
Starting Ending LBA Info:
#: id C H S - C H S [ start: size ]
-------------------------------------------------------------------------------
0: 83 0 32 33 - 58743 224 41 [ 2048: 943718400 ]
Linux files*
1: 0C 58743 224 42 - 58746 109 51 [ 943720448: 40960 ]
FAT32L
2: A6 58746 109 52 - 118795 153 14 [ 943761408: 964689920 ]
OpenBSD
3: 00 0 0 0 - 0 0 0 [ 0: 0 ]
unused
U-Boot 2017.03 (Apr 03 2017 - 11:14:00 -0600) Allwinner Technology
CPU: Allwinner A10 (SUN4I)
Model: Olimex A10-OLinuXino-LIME
I2C: ready
DRAM: 512 MiB
MMC: SUNXI SD/MMC: 0
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
SCSI: Target spinup took 0 ms.
AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
flags: ncq stag pm led clo only pmp pio slum part ccc apst
Net: eth0: ethernet@01c0b000
starting USB...
USB0: USB EHCI 1.00
USB1: USB OHCI 1.0
USB2: USB EHCI 1.00
USB3: USB OHCI 1.0
scanning bus 0 for devices... 2 USB Device(s) found
scanning bus 2 for devices... 1 USB Device(s) found
scanning bus 1 for devices... 1 USB Device(s) found
scanning bus 3 for devices... 2 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot: 0
switch to partitions #0, OK
mmc0 is current device
Scanning mmc 0:1...
Found EFI removable media binary efi/boot/bootarm.efi
reading efi/boot/bootarm.efi
64684 bytes read in 41 ms (1.5 MiB/s)
libfdt fdt_check_header(): FDT_ERR_BADMAGIC
## Starting EFI application at 42000000 ...
Scanning disks on scsi...
Scanning disks on usb...
Scanning disks on mmc...
MMC Device 1 not found
MMC Device 2 not found
MMC Device 3 not found
Found 6 disks
OpenBSD/armv7 BOOTARM 0.5
boot>
cannot open sd0a:/etc/random.seed: No such file or directory
booting sd0a:/bsd: 2151556+7983908+438824 [80+301248+143324]=0xa84fd4
...
sd0 at scsibus0 targ 0 lun 0: <ATA, TOSHIBA MQ01ABD1, AX00> SCSI3
0/direct fixed naa.5000039514a065a8
sd0: 953869MB, 512 bytes/sector, 1953525168 sectors
...
sd1 at scsibus1 targ 1 lun 0: <Sandisk, SA08G, 0021> SCSI2 0/direct
removable
sd1: 7420MB, 512 bytes/sector, 15196160 sectors
axe0 at uhub0 port 1 configuration 1 interface 0 "ASIX Electronics
AX88772B" rev 2.00/0.01 addr 2
axe0: AX88772B, address 00:00:00:00:00:01
ukphy0 at axe0 phy 16: Generic IEEE 802.3u media interface, rev. 1: OUI
0x000ec6, model 0x0008
boot device: sd0
root on rd0a swap on rd0b dump on rd0b
WARNING: preposterous clock chip time
WARNING: CHECK AND RESET THE DATE!
erase ^?, werase ^W, kill ^U, intr ^C, status ^T
Welcome to the OpenBSD/armv7 6.1 installation program.
(I)nstall, (U)pgrade, (A)utoinstall or (S)hell? shell
