Of course, that would be half duplex as well. So if you have symmetrical
traffic, it would be ~~ 50Mbps per side.
--
bp
part15sbs{at}gmail{dot}com
On Tue, May 24, 2022 at 2:25 PM Josh Luthman <j...@imaginenetworksllc.com>
wrote:
> 5 b/hz on Force 200. About 100 meg aggregate. Perfect signal, no noise.
> Force 300 won't be all that much better unless you have a better signal
> anyway.
>
> On Tue, May 24, 2022 at 3:26 PM <dmmoff...@gmail.com> wrote:
>
>> Yeah I was thinking you’d not quite get a full 100mb on a 20mhz channel.
>> Might be 80-90.
>>
>> I would plan on 5.6ghz and 40mhz.
>>
>>
>>
>> -Adam
>>
>>
>>
>>
>>
>> *From:* AF <af-boun...@af.afmug.com> *On Behalf Of *Steve Jones
>> *Sent:* Tuesday, May 24, 2022 12:50 PM
>> *To:* AnimalFarm Microwave Users Group <af@af.afmug.com>
>> *Subject:* Re: [AFMUG] EPMP PTP Throughput
>>
>>
>>
>> for not critical i use f200 in DFS and 40mhz. Radio speedtests will show
>> that throughput
>>
>>
>>
>> On Tue, May 24, 2022 at 11:34 AM Ryan Ray <ryan...@gmail.com> wrote:
>>
>> You'll be right on the edge. Should work.
>>
>>
>>
>> On Tue, May 24, 2022 at 8:25 AM Nate Burke <n...@blastcomm.com> wrote:
>>
>> I need to do a 1 mile PTP hop on the cheap. Only looking for ~100mb. I
>> have a set of EPMP Force 200 radios on the shelf. Can I get 100mb out
>> of a 20mhz channel in ePTP Mode with a pair of Force200s? I'm pretty
>> sure a set of Force300's could do it, but the boss want's me to use some
>> old stock inventory for this.
>>
>>
>>
>> --
>> AF mailing list
>> AF@af.afmug.com
>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>>
>> --
>> AF mailing list
>> AF@af.afmug.com
>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>>
>> --
>> AF mailing list
>> AF@af.afmug.com
>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>>
> --
> AF mailing list
> AF@af.afmug.com
> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
