Chuck, I'll try swapping one to see what happens.
-- Best regards, Mark mailto:m...@mailmt.com Myakka Technologies, Inc. www.Myakka.com ------ Tuesday, July 2, 2019, 5:48:02 PM, you wrote: cwc> They always shut off for me. But it seems like I wired one up backwards cwc> once and it would either not switch right or not trip or something. cwc> It certainly was polarity sensitive. cwc> -----Original Message----- cwc> From: Mark - Myakka Technologies cwc> Sent: Tuesday, July 2, 2019 3:42 PM cwc> To: AnimalFarm Microwave Users Group cwc> Subject: Re: [AFMUG] LELK1-1REC4-34171 breaker cwc> Chuck, cwc> I'm very confused with them, that's why I'm asking the experts. They cwc> look like normal breakers, but they are not acting that way. They do cwc> have a line and load side. I have them setup with line on the hot cwc> side and load on the equipment side. Just not acting the way I cwc> expected. I just will make sure a put a note up not to assume the cwc> circuit is disconnect if you switch the breaker to OFF. cwc> -- cwc> Best regards, cwc> Mark mailto:m...@mailmt.com cwc> Myakka Technologies, Inc. cwc> www.Myakka.com cwc> ------ cwc> Tuesday, July 2, 2019, 5:26:57 PM, you wrote: cwc>> Those are DC circuit breakers. cwc>> Pretty common. cwc>> They may be polarity sensitive. I think I have run into this problem cwc>> before. cwc>> -----Original Message----- cwc>> From: Ken Hohhof cwc>> Sent: Tuesday, July 2, 2019 1:54 PM cwc>> To: 'AnimalFarm Microwave Users Group' cwc>> Subject: Re: [AFMUG] LELK1-1REC4-34171 breaker cwc>> Nope, but this appears to be the spec sheet: cwc>> http://airpax.sensata.com/pdfs/ial.pdf cwc>> -----Original Message----- cwc>> From: AF <af-boun...@af.afmug.com> On Behalf Of Mark - Myakka cwc> Technologies cwc>> Sent: Tuesday, July 2, 2019 2:37 PM cwc>> To: 'AnimalFarm Microwave Users Group' <af@af.afmug.com> cwc>> Subject: [AFMUG] LELK1-1REC4-34171 breaker cwc>> Was working on the -48vdc power plant the last few days due to battery cwc>> issues. Noticed that what I though was a breaker, may not be a cwc>> breaker. cwc>> I have a total of 6 of these LELK1-1REC4-34171 in the system. They cwc> show cwc>> they have a delay and make mention they are "Special Purpose Not for cwc> General cwc>> use" cwc>> Anyone familiar with these? They have the normal on/off switch of a cwc>> normal breaker. But I discovered that even in the off position current cwc> is cwc>> being passed. I find it hard to belive I have six bad units that have cwc>> been purchased from multiple places over the past years. Are they cwc>> designed this way? Is so, what is their purpose? Seems like a bit of cwc> a cwc>> safety risk. cwc>> -- cwc>> Thanks, cwc>> Mark mailto:m...@mailmt.com cwc>> Myakka Technologies, Inc. cwc>> www.Myakka.com cwc>> -- cwc>> AF mailing list cwc>> AF@af.afmug.com cwc>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com cwc>> -- cwc>> AF mailing list cwc>> AF@af.afmug.com cwc>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com cwc> -- cwc> AF mailing list cwc> AF@af.afmug.com cwc> http://af.afmug.com/mailman/listinfo/af_af.afmug.com -- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
