Here it is, maybe not the best description but it should be clear enough : https://www.ibm.com/developerworks/rfe/execute?use_case=viewRfe&CR_ID=100363 Go vote if you want IBM to add a switch like this to the replicate node command and thanks for the reply's!
On Wed, Feb 1, 2017 at 12:48 PM, Conny Landstedt <conny.landst...@sll.se> wrote: > I would vote for that RFE, I see the same issue with our setup. > > Adding an option like wherereplstate=SEND,SENDSYNC would solve this issue. > > Best regards > Conny Landstedt > > > Do you guys think that would be worth an RFE? > > I think so, yes. > We're struggling with the same problem; for now we were just ignoring > those ANR2728E messages, because avoiding them would make our daily > maintenance script way to complicated. > We have an open PMR at the moment where IBM support is asking us the > following: > > --- > I noticed in the ACT LOG, there are a lot of ANR2728E. > > ANR2728E REPLICATE NODE: Node CLGHV001_DBGHV001PROD > cannot be replicated because it is not in the > SEND or > SYNCSEND mode. (SESSION: 2937994, PROCESS: 5406) > > Are these nodes supposed to be replicated? If so, please have the customer > correct the issue. > Otherwise, I recommend the customer remove them from their replication. > This will keep things clean and not add any extra noise as we analyze the > problem. > --- > > Yes, well, if there were an elegant way of removing them from replication, > we would. > > Two servers doing cross replication seems like an obvious setup, where you > will always bump into this problem. > A replicate node option like you describe would help us out and apparently > answers to a need of IBM support as well. > > Regards, > Frederik de Kezel > > -----Original Message----- > From: ADSM: Dist Stor Manager [mailto:ADSM-L@VM.MARIST.EDU] On Behalf Of > Stefan Folkerts > Sent: maandag 30 januari 2017 09:50 > To: ADSM-L@VM.MARIST.EDU > Subject: [ADSM-L] Thinking about replicate node command RFE, feedback > welcome > > Hi all, > > I'm thinking about creating an RFE for the replicate node command but I > was wondering if I might be missing something so obvious that my RFE would > be nonsense. > > I try to create setups without and errors or warnings from housekeeping > scripts. > I also try to work with opt-out mechanisms as much as possible for > customers that agree to use that backup philosophy. > > When you build a two-way replicating Spectrum Protect setup using node > replication (with or without protect stgpool) you get a LOT of errors of > this type. > > ANR2728E REPLICATE NODE: Node <Nodename> cannot be replicated because it > is not in the SEND or SENDSYNC mode. > > You either have to use nodegroups, single nodes or accept these messages, > this doesn't work with an opt-out policy. > Why isn't there a replicate node option like with move drmedia where you > can say something like wherereplstate=SEND,SENDSYNC. > > Do you guy's think that would be worth an RFE? > > Regards, > Stefan >
