Joseph L. Casale wrote:
I apologize for replying in the middle of this thread, but I never
saw the initial snapshot syntax of mypool2, which needs to be
recursive (zfs snapshot -r mypo...@snap) to snapshot all the
datasets in mypool2. Then, use zfs send -R to pick up and
restore all the dataset properties.
What was the original snapshot syntax?
Cindy,
You figured it out! I forgot the -r :)
I don't have the room to try to send locally so I reran the ssh
and it's showing what would get transferred with Ian's syntax.
I just ran the following:
zfs send -vR mypo...@snap |ssh j...@host "pfexec /usr/sbin/zfs recv -Fdnv
mypool/zfsname"
Looking at the man page, it doesn't explicitly state the behavior I am
noticing but looking at the switch's, I can see a _lot_ of traffic going
from the sending host to the receiving host. Does the -n just not write it
but allow it to be sent? The command has not returned...
Correct, the sending side will be happily sending into a void.
Kill it and re-run without the -n.
--
Ian.
_______________________________________________
zfs-discuss mailing list
zfs-discuss@opensolaris.org
http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
