Could you explain if you did any specific configuration on the Areca Raid controller other than setting it to Raid and manually marking every disk as pass-trhough so that the disks are viewable from opensolaris?
I have an ARC-1680ix-16. I have tried two configurations. JBOD and RAID but making all drives pass-through as you suggest. In both Instances, I can only see two hard drives from opensolaris. I have tried a RHEL 5.2 Installation with the Areca controller and I can see all the drives using RAID with pass-through. Do I need any boot parameters for opensolaris or something else? The Areca controller assigned the following settings for the drives when configured as pass-through Channel-SCSI_ID-LUN Disk# 0-0-0 01 0-0-1 02 0-0-2 03 0-0-3 04 0-0-4 05 0-0-5 06 0-0-6 07 0-0-7 08 ---------- 0-1-0 09 0-1-1 10 0-1-2 11 0-1-3 12 0-1-4 13 0-1-5 14 0-1-6 15 0-1-7 16 My Firmware is 1.45 and I am using the areca driver that comes with opensolaris 2008.11 Any help would be greatly appreciated. -- This message posted from opensolaris.org _______________________________________________ zfs-discuss mailing list zfs-discuss@opensolaris.org http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
