Hello Kam, Friday, January 25, 2008, 9:11:24 AM, you wrote:
K> zpool status shows a few checksum errors against 1 device in a K> raidz1 3 disk array and no read or write errors against that K> device. The pool marked as degraded. Is there a difference if you K> clear the errors for the pool before you scrub versus scrubing then K> clearing the errors? I'm not sure if the clearing errors prior to a K> scrub will replicate out any bad blocks that were identified as K> checksum errors previously that had since been cleared. K> It doesn't mater - scrub won't replicate any errors. Now if these errors were correctable errors they were corrected by zfs at the same time it discovered them. Could you post zpool satus output? -- Best regards, Robert Milkowski mailto:[EMAIL PROTECTED] http://milek.blogspot.com _______________________________________________ zfs-discuss mailing list zfs-discuss@opensolaris.org http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
