zpool status shows a few checksum errors against 1 device in a raidz1 3 disk
array and no read or write errors against that device. The pool marked as
degraded. Is there a difference if you clear the errors for the pool before you
scrub versus scrubing then clearing the errors? I'm not sure if the clearing
errors prior to a scrub will replicate out any bad blocks that were identified
as checksum errors previously that had since been cleared.
This message posted from opensolaris.org
_______________________________________________
zfs-discuss mailing list
zfs-discuss@opensolaris.org
http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
