Hi, On Dec 5, 2012, at 5:21 PM, Andreas Schweigstill <andr...@schweigstill.de> wrote:
> I have also tried to build a kernel and root filesystem for Zynq but the > kernel > gets stuck when booting, regardless if on the ZC702 board or on Qemu. I tried > Poky denzil and Poky danny. > > Also the alternate meta-zynq layer from git.yoctoproject.org shows the same > behaviour. > > These are the last console messages which I get: > ## Booting kernel from Legacy Image at 01000000 ... > Image Name: Linux-3.2.11-yocto-standard > Created: 2012-12-04 20:07:37 UTC > Image Type: ARM Linux Kernel Image (uncompressed) > Data Size: 2997472 Bytes = 2.9 MiB > Load Address: 00008000 > Entry Point: 00008000 > Verifying Checksum ... OK > ## Flattened Device Tree blob at 01a80000 > Booting using the fdt blob at 0x1a80000 > Loading Device Tree to 0eff8000, end 0efff185 ... OK > Loading Kernel Image ... OK > OK > Loading Device Tree to 0efed000, end 0eff7185 ... OK > > Starting kernel ... > > > Instead of using Linux kernel version 3.5-xilinx I always get > Linux-3.2.11-yocto-standard which is obviously missing the > Zynq patches. > > meta-zynq/recipes-kernel-linux-zynq contains the following lines: > LINUX_VERSION ?= "3.5" > LINUX_VERSION_EXTENSION ?= "-xilinx" > > How can I force Yocto to build kernel 3.5-xilinx? > >From you messages, I infer that you are using the meta-zynq layer located here: http://git.yoctoproject.org/cgit/cgit.cgi/meta-zynq/ For my builds, I used Philip Ballister's meta-zynq layer located here for the simple reason that it uses xilinx git repository: https://github.com/balister/meta-zynq Also, try to ensure that you don't put both the meta-layers in your bblayers.conf file while building, and ensure that you set machine as follows in your local.conf file MACHINE ?= "zynq-zc702" Do let me know how it goes! Best regards, Elvis Dowson _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto
