On Sunday 06 July 2003 03:10, Ges wrote: Gesly, I ran into the same problem. And I finished in the same hole that you did. I had to reinstall my Redhat again. And unfortunately it happened again. After second reinstallation I picked the proper frequency interval during you video mode setup. Previously I set my frequency interval to wide to make sure my monitor will match it. But it caused this xserver crash. 3rd time I set the interval not so wide but still correct. And from this point it's working fine. so far.
Not understandable explanation for it, but works for me. And I haven't change any hardware or software. And using similar configuration to yours. Intel 810, P3 1GHz. So good luck mark > Hi, > > I am having a problem with Xfree86. I am attaching the log file with this > mail I am using REDHAT 9 on a Intel 815e with a Pentium 3 733Mhz processor. > I am using the onboard graphics controller. > > When i booted into my linux it suddenly showed that cannot load module > bitmap and xserver wouldnt start. > > I tried to reinstall by using the update option from the redhat cds but it > failed. It was unable to reinsatll xfree86. > > I had to reinstall my linux. > > Again i'm having the same problem. Last time it happened after i had a > problem with xine. Whenever i ran xine it would log out of the GUI mode and > after 2 such trials xserver would crash. > > I hopw u will be able to help me with this problem. Right now i'm stuck... > i need to get my xserver running as soon as possible. > > Please help > > -Gesly > > > > --------------------------------- > Do you Yahoo!? > SBC Yahoo! DSL - Now only $29.95 per month! _______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86
