There are several different methods for configuring X, plus some
distro specific configuration options. In addition to XFree86 -configure,
you can try XF86cfg, and XF86config. There is also a Debian specific method,
but I've forgotten the syntax.
As far as whether your card is supported I don't know, but you can try using
the vesa or vga drivers in the meantime. I'd try the Vesa driver first.
It shouldn't be necessary to install from scratch, although you should run
the latest version whenever possible.
The problem with you 4.1.0.1 setup was that your card was not supported in
the version, that's why you received a "no devices" error. Although you
could probably use the Vesa driver there too. You should note that the Vesa
and vga drivers do not support hardware 3D acceleration.
HTH,
cyn
-----Original Message-----
From: Giorgio P. [mailto:[EMAIL PROTECTED]
Sent: Friday, May 30, 2003 10:12 AM
To: [EMAIL PROTECTED]
Subject: [XFree86] My problem with XFree86
_______________________________________________
XFree86 mailing list
[EMAIL PROTECTED]
http://XFree86.Org/mailman/listinfo/xfree86
