On 05.03.25 11:11, Mykola Kvach wrote:
From: Mykola Kvach <mykola_kv...@epam.com>

The changes have been tested only on the Renesas R-Car-H3 Starter Kit board.

Signed-off-by: Volodymyr Babchuk <volodymyr_babc...@epam.com>
Signed-off-by: Oleksandr Andrushchenko <oleksandr_andrushche...@epam.com>
Signed-off-by: Mykola Kvach <mykola_kv...@epam.com>
---
  xen/drivers/char/scif-uart.c | 31 ++++++++++++++++++++++++++++++-
  1 file changed, 30 insertions(+), 1 deletion(-)

diff --git a/xen/drivers/char/scif-uart.c b/xen/drivers/char/scif-uart.c
index 757793ca45..e166fb0f36 100644
--- a/xen/drivers/char/scif-uart.c
+++ b/xen/drivers/char/scif-uart.c
@@ -139,7 +139,7 @@ static void scif_uart_interrupt(int irq, void *data)
      }
  }
-static void __init scif_uart_init_preirq(struct serial_port *port)
+static void scif_uart_init_preirq(struct serial_port *port)
  {
      struct scif_uart *uart = port->uart;
      const struct port_params *params = uart->params;
@@ -271,6 +271,33 @@ static void scif_uart_stop_tx(struct serial_port *port)
      scif_writew(uart, SCIF_SCSCR, scif_readw(uart, SCIF_SCSCR) & ~SCSCR_TIE);
  }

I assume you want ifdef CONFIG_SYSTEM_SUSPEND here also


+static void scif_uart_suspend(struct serial_port *port)
+{
+    struct scif_uart *uart = port->uart;
+
+    scif_uart_stop_tx(port);
+
+    /* Wait until last bit has been transmitted. */
+    while ( !(scif_readw(uart, SCIF_SCFSR) & SCFSR_TEND) );
+
+    /* Disable TX/RX parts and all interrupts */
+    scif_writew(uart, SCIF_SCSCR, 0);
+
+    /* Reset TX/RX FIFOs */
+    scif_writew(uart, SCIF_SCFCR, SCFCR_RFRST | SCFCR_TFRST);
+}
+
+static void scif_uart_resume(struct serial_port *port)
+{
+    struct scif_uart *uart = port->uart;
+
+    scif_uart_init_preirq(port);
+
+    /* Enable TX/RX and Error Interrupts  */
+    scif_writew(uart, SCIF_SCSCR, scif_readw(uart, SCIF_SCSCR) |
+                SCSCR_TIE | SCSCR_RIE | SCSCR_REIE);
+}
+
  static struct uart_driver __read_mostly scif_uart_driver = {
      .init_preirq  = scif_uart_init_preirq,
      .init_postirq = scif_uart_init_postirq,
@@ -281,6 +308,8 @@ static struct uart_driver __read_mostly scif_uart_driver = {
      .start_tx     = scif_uart_start_tx,
      .stop_tx      = scif_uart_stop_tx,
      .vuart_info   = scif_vuart_info,
+    .suspend      = scif_uart_suspend,
+    .resume       = scif_uart_resume,
  };
static const struct dt_device_match scif_uart_dt_match[] __initconst =

--
Best regards,
-grygorii

Reply via email to