On 01/06/15 12:25, Zoltan Kiss wrote:
> Hi,
> 
> Yes, we managed to test it, and it works. Then only thing I've found is
> this bit:
> 
> +    /* Only 1020 interrupts are supported */
> +    gicv2_info.nr_lines = min(1020U, nr_lines);
> 
> This interrupt controller only supports 511, so 1020 should be replaced.
> We had such checking in the code in the early versions, and I looked
> everywhere in the archives to figure out why it was dropped before
> upstreaming, but I couldn't find it.

I'm aware of the 512 limit (see comment on the patch [1]). This change
was introduced on GICv2/GICv3 because the nr_lines will always be
aligned to 32, although IRQ 1020-1023 are reserved.

512 is a multiple of 32 and unless you have reserved IRQ below 512
and/or your GIC doesn't expose the right number of IRQ, this doesn't
harm and keep the change limited.

> Other than this bit:
> 
> Reviewed-by: Zoltan Kiss <zoltan.k...@huawei.com>
> Tested-by: Shameerali Kolothum Thodi <shameerali.kolothum.th...@huawei.com>

Thanks. Can I get some Acked/Review on the other pending patch series?

http://lists.xenproject.org/archives/html/xen-devel/2015-05/msg00944.html :
6 patches to ack.

Regards,

[1] https://patches.linaro.org/46100/


-- 
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xen.org
http://lists.xen.org/xen-devel

Reply via email to