I don't see it, but there has to be a typo in weewx.conf someplace. My old Tempest weewx.conf is at https://community.weatherflow.com/t/weewx-udp-driver-for-weatherflow-station/283/189 if you want to take a look there. Of course you'll have to edit in your serial numbers for your sensor.
On Saturday, May 1, 2021 at 2:02:40 PM UTC-7 [email protected] wrote: > > I am using this udp driver" > https://github.com/captain-coredump/weatherflow-udp > > log attached > > snip from log: > May 1 17:01:19 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'fs': [1, 0, 15675411, 524288], 'seq': 837, 'firmware_revision': > '169', 'timestamp': 1619902878, 'serial_number': 'HB-00012441', 'uptime': > 8414, 'reset_flags': 'BOR,PIN,POR', 'mqtt_stats': [49, 0], 'rssi': -25, > 'type': 'hub_status', 'radio_stats': [5, 1, 0, 3, 0]} > May 1 17:01:20 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'firmware_revision': 134, 'timestamp': 1619902879, 'voltage': > 2.585, 'rssi': -68, 'hub_sn': 'HB-00012441', 'uptime': 19985, 'hub_rssi': > -60, 'sensor_status': 0, 'debug': 0, 'serial_number': 'ST-00021019', > 'type': 'device_status'} > May 1 17:01:20 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'firmware_revision': 134, 'serial_number': 'ST-00021019', 'type': > 'obs_st', 'obs': [[1619902879, 0.54, 3.03, 5.93, 215, 3, 967.62, 16.41, > 29.09, 63223, 2.87, 527, 0.0, 0, 0, 0, 2.585, 1]], 'hub_sn': 'HB-00012441'} > May 1 17:01:22 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'serial_number': 'ST-00021019', 'type': 'rapid_wind', 'ob': > [1619902881, 2.24, 196], 'hub_sn': 'HB-00012441'} > May 1 17:01:22 raspberrypi weewx[1884] INFO weewx.restx: MQTT: Published > record 2021-05-01 17:01:21 EDT (1619902881) > May 1 17:01:25 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'serial_number': 'ST-00021019', 'type': 'rapid_wind', 'ob': > [1619902884, 2.24, 205], 'hub_sn': 'HB-00012441'} > May 1 17:01:25 raspberrypi weewx[1884] INFO weewx.restx: MQTT: Published > record 2021-05-01 17:01:24 EDT (1619902884) > May 1 17:01:28 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'serial_number': 'ST-00021019', 'type': 'rapid_wind', 'ob': > [1619902887, 1.88, 248], 'hub_sn': 'HB-00012441'} > May 1 17:01:28 raspberrypi weewx[1884] INFO weewx.restx: MQTT: Published > record 2021-05-01 17:01:27 EDT (1619902887) > May 1 17:01:29 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'fs': [1, 0, 15675411, 524288], 'seq': 838, 'firmware_revision': > '169', 'timestamp': 1619902888, 'serial_number': 'HB-00012441', 'uptime': > 8424, 'reset_flags': 'BOR,PIN,POR', 'mqtt_stats': [49, 0], 'rssi': -26, > 'type': 'hub_status', 'radio_stats': [5, 1, 0, 3, 0]} > May 1 17:01:31 raspberrypi weewxd: weatherflowudp: MainThread: raw > packet: {'serial_number': 'ST-00021019', 'type': 'rapid_wind', 'ob': > [1619902890, 2.64, 240], 'hub_sn': 'HB-00012441'} > May 1 17:01:31 raspberrypi weewx[1884] INFO weewx.restx: MQTT: Published > record 2021-05-01 17:01:30 EDT (1619902890) > > > On Sat, May 1, 2021 at 4:24 PM vince <[email protected]> wrote: > >> Without seeing your logs, it's uncertain what you're seeing. >> We also don't know which driver of the many WF drivers to pick from you >> are running. >> >> The FAQ <https://github.com/weewx/weewx/wiki/faq-how-to-report-a-problem> >> has >> more info on how to give us enough information to understand your system. >> >> It is almost certain that you have a typo in your sensor_map especially >> since you see rapid_wind but not anything obs_st being recorded. >> >> That said, you might want to run my standalone WF UDP listener (link) >> <https://github.com/vinceskahan/weatherflow-udp-listener> with the --raw >> --debug flags to see what your Hub is emitting in its UDP. The github >> page has too much info on how to run the listener to repeat here. >> >> On Saturday, May 1, 2021 at 1:10:57 PM UTC-7 [email protected] wrote: >> >>> I recently upgraded to the Tempest. I updated my weewx.conf file for the >>> new sensor map. >>> >>> The only thing that is recording is the wind speed and direction. >>> >>> I checked the log and the packets are there. >>> >>> When i revert back to my AIR it works fine. >>> >>> Any help would be appreciated. >>> >>> [[sensor_map]] >>> outTemp = air_temperature.ST-00021019.obs_st >>> outHumidity = relative_humidity.ST-00021019.obs_st >>> pressure = station_pressure.ST-00021019.obs_st >>> lightning_strike_count = lightning_strike_count.ST-00021019.obs_st >>> lightning_distance = lightning_strike_avg_distance.ST-00021019.obs_st >>> outTempBatteryStatus = battery.ST-00021019.obs_st >>> windSpeed = wind_speed.ST-00021019.rapid_wind >>> windDir = wind_direction.ST-00021019.rapid_wind >>> luxXXX = illuminance.ST-00021019.obs_st >>> UV = uv.ST-00021019.obs_st >>> rain = rain_accumulated.ST-00021019.obs_st >>> windBatteryStatus = battery.ST-00021019.obs_st >>> radiation = solar_radiation.ST-00000025.obs_st >>> >> -- >> You received this message because you are subscribed to the Google Groups >> "weewx-user" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> To view this discussion on the web visit >> https://groups.google.com/d/msgid/weewx-user/5f4b21b3-c704-4e41-954a-5fc6a6fd63aen%40googlegroups.com >> >> <https://groups.google.com/d/msgid/weewx-user/5f4b21b3-c704-4e41-954a-5fc6a6fd63aen%40googlegroups.com?utm_medium=email&utm_source=footer> >> . >> > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/8fd3e21f-6dc0-4659-adad-8c7c21627ec2n%40googlegroups.com.
