Axil,
I think there is much room for improvement with any cooling
scheme that increases heat sinking to the skin of the reactor since the device
can overheat and self-destruct faster than the heat sinking can propagate into
the reactor [keeping us forever at this narrow window where a pwm heater only
just teases the reactor into balancing on the head of a pin, If we had truly
active cooling inside the reactor we could use the same pwm idea used for the
drive to open this window wide enough to operate easily in self sustained mode.
There must be some method to cool the reactor faster[duty factor] without the
thermal delay time, maybe some kind of insulation layer that can be duty factor
modulated combined with the over heat sinking/ submerged reactor such that
turning off the insulation would immediately kill the reaction [submerged
reactor?].. am I wrong to think that turning on an off an internal insulator
would allow faster thermal modulation inside the reactor than adjusting
external air or liquid flow? Maybe someone could speak to possible ways to
accomplish this? Electrical control of material to vary thermal property? Cycle
between inert and thermally conductive gas chambers lining the inner reactor
wall?
Fran
From: Axil Axil [mailto:[email protected]]
Sent: Tuesday, May 26, 2015 11:25 PM
To: vortex-l
Subject: EXTERNAL: Re: [Vo]:info- not much for May 26, 2015
https://www.facebook.com/MartinFleischmannMemorialProject
There might be something to this. Rossi placed ridges on the surface of the Hot
cat. This might have been an attempt to keep the Hot cat from overheating
through increased convective cooling. Rossi replication attemps do not do this.
Rossi would not have put these ridges on the surface of his reactor for no good
reason, The same increased cooling effect might be had by cooling the reactor
with a stream of air...fan cooling???
Using a variable speed fan could allow the experimenter to adjust the degree of
reactor cooling at will.
If this concept is valid, start a Hot cat test with a large amount of fan
cooling. Then the reaction might not start at 1200C. reduce the cooling in
stages until the reaction starts or the reactor melts down.
There is a great deal of consideration directed toward the ridges in the Lagano
report. From the Lagano test report...
"The reactor investigated on this occasion is outwardly quite different from
the ones used in the tests held in
the past years. Its external appearance is that of an alumina cylinder, 2 cm in
diameter and 20 cm in length,
ending on both sides with two cylindrical alumina blocks (4 cm in diameter, 4
cm in length), non-detachable
from the body of the reactor, which henceforth will be referred to as “caps”.
An image of the reactor is given
in Figure1. Whereas the surface of the caps is smooth, the outer surface of the
body of the E-Cat is molded in
triangular ridges, 2.3 mm high and 3.2 mm wide at the base, covering the entire
surface and designed to
improve convective thermal exchange (cylinder diameter is calculated from the
bases of the ridges). In this
way, the current model of E-Cat is capable of attaining higher temperatures
than the earlier models, avoiding
internal melting, a previously fairly frequent occurrence [1]."
On Tue, May 26, 2015 at 1:12 PM, Peter Gluck
<[email protected]<mailto:[email protected]>> wrote:
That's all:
http://egooutpeters.blogspot.ro/2015/05/just-bit-info-for-may-26-2015.html
More to come
Peter
--
Dr. Peter Gluck
Cluj, Romania
http://egooutpeters.blogspot.com