https://www.facebook.com/MartinFleischmannMemorialProject
There might be something to this. Rossi placed ridges on the surface of the Hot cat. This might have been an attempt to keep the Hot cat from overheating through increased convective cooling. Rossi replication attemps do not do this. Rossi would not have put these ridges on the surface of his reactor for no good reason, The same increased cooling effect might be had by cooling the reactor with a stream of air...fan cooling??? Using a variable speed fan could allow the experimenter to adjust the degree of reactor cooling at will. If this concept is valid, start a Hot cat test with a large amount of fan cooling. Then the reaction might not start at 1200C. reduce the cooling in stages until the reaction starts or the reactor melts down. There is a great deal of consideration directed toward the ridges in the Lagano report. From the Lagano test report... "The reactor investigated on this occasion is outwardly quite different from the ones used in the tests held in the past years. Its external appearance is that of an alumina cylinder, 2 cm in diameter and 20 cm in length, ending on both sides with two cylindrical alumina blocks (4 cm in diameter, 4 cm in length), non-detachable from the body of the reactor, which henceforth will be referred to as “caps”. An image of the reactor is given in Figure1. Whereas the surface of the caps is smooth, the outer surface of the body of the E-Cat is molded in triangular ridges, 2.3 mm high and 3.2 mm wide at the base, covering the entire surface and designed to improve convective thermal exchange (cylinder diameter is calculated from the bases of the ridges). In this way, the current model of E-Cat is capable of attaining higher temperatures than the earlier models, avoiding internal melting, a previously fairly frequent occurrence [1]." On Tue, May 26, 2015 at 1:12 PM, Peter Gluck <[email protected]> wrote: > That's all: > > http://egooutpeters.blogspot.ro/2015/05/just-bit-info-for-may-26-2015.html > > More to come > > Peter > > -- > Dr. Peter Gluck > Cluj, Romania > http://egooutpeters.blogspot.com >

