Greetings, I've completed a thorough search through the posting to configure my router appropriatly to no avail. Can someone help?
I have a linksys router BEFW11S4 with the latest firmware installed. I use Comacst cable internet access. I have the following configurations on the router: Filters: Enable MTU 1492 Disabel Block WAN Request Forwarding: 5900 to 6000 TCP [IP of LAN side server] Enable 5800 to 5800 TCP ["] Enable Nothing enabled under UPnP nor Port Triggering When testing this out from a computer WITHIN and OUTSIDE my LAN using the external IP of router (68.35.xxx.xxx), it's Default Getway IP(68.35.xxx.x), and it's LAN IP address (from within the LAN of course) WITH and WITHOUT the ":5900" port designation (i.e., 68.35.###.###:5900). It waits for a bit like it's going to connect then I get an error "Connection to Server Failed" (So close yet so far). I've tried DHCP enabled and disabled. I'm at a loss. I want to play too! I'd appreciate some guidance. Sincerely frustrated, Lorenzo ===== Regards, Lorenzo Gutierrez _______________________________________________ VNC-List mailing list [EMAIL PROTECTED] http://www.realvnc.com/mailman/listinfo/vnc-list
