Hello Community, I have two X410s with UHD 4.5. They are sync with an OctoClock, so I am using external clock and time.The problem is that whenever I start a test, X410s do ADC self calibration twice, in the 1st time, they calibrate with internal clock, and the 2nd time is due to my configuration of external clock. Self cal takes time. I need to run the test many times for debug, which means that this self cal is run many times, but all hardware connections and software configurations are not changed in test, so I hope the ADC calibration can be done only once and the cal results can be reused (e.g., save in a file and X410s just load them at the beginning of each test). This will save a lot of cal time and this is the best solution. If not the best, I can accept a suboptimal solution - calibrate once rather than twice. This means that I need to configure external clock in make command. Is it possible to configure make for this purpose? Any suggestion will be appreciated. Kind regards,H.
_______________________________________________ USRP-users mailing list -- usrp-users@lists.ettus.com To unsubscribe send an email to usrp-users-le...@lists.ettus.com
