Hello Martin, Can you please suggest some check points. I tried to run an example including uhd source and sink in gnu radio. The TX and RX works at the same time, but with rfnoc block either TX or RX works at a time.
Regards, Nidhi ________________________________ From: Nidhi Panda <nidhi.pa...@cyronics.com> Sent: Monday, November 11, 2024 4:02 PM To: Martin Braun <martin.br...@ettus.com> Subject: Re: [USRP-users] RFNoC TX and RX not working simulataniously There is no error message on GNU radio but when TX and RX both are on, we are not able to see transmitted signal on spectrum analyzer. However, if we disable the RX chain on the same GNU radio example, the transmitted signal is present. ________________________________ From: Martin Braun <martin.br...@ettus.com> Sent: Monday, November 11, 2024 2:39 PM To: Nidhi Panda <nidhi.pa...@cyronics.com> Cc: usrp-users@lists.ettus.com <usrp-users@lists.ettus.com> Subject: Re: [USRP-users] RFNoC TX and RX not working simulataniously On Sat, Nov 9, 2024 at 12:47 PM Nidhi Panda <nidhi.pa...@cyronics.com<mailto:nidhi.pa...@cyronics.com>> wrote: Hello all, I am using USRP n300 board. I have tested Rfnoc TX radio and RFNoC Rx radio chain separately. But when we try to run both the chain at the same time TX does not seem to work. Any suggestion what might went wrong in this. What's the error? --M
_______________________________________________ USRP-users mailing list -- usrp-users@lists.ettus.com To unsubscribe send an email to usrp-users-le...@lists.ettus.com
