On 2022-06-09 11:05, White, Joshua J wrote:
Hello,
Apologies if this question is too basic, but I have not been able to
find a definitive answer in the N310 documentation. Is it possible to
stream data or signals to or from the USRP using the GPIO ports, or is
it only useful for status and triggering? Specifically, is it possible
to use the GPIO to stream an arbitrary waveform to the N310, digitize
it, and then modulate and transmit it? Conversely, is it possible to
receive a signal, demodulate and stream it to the GPIO?
Very respectfully,
**
*Joshua White *
Precision Timing Systems Engineer
Engineering & Support Solutions Directorate
www.riversideresearch.org <http://www.riversideresearch.org/>
T: 937.986.3153 | F: 937.431.3811
This e-mail message, including any attachments, is for the sole use of
the intended recipient(s) and may contain proprietary, confidential or
privileged information or otherwise be protected by law. Any
unauthorized review, use, disclosure or distribution is prohibited. If
you are not the intended recipient, please notify the sender and
destroy all copies and the original message.
The GPIOs are intended only for low-rate status/triggers/external
hardware controls.
_______________________________________________
USRP-users mailing list -- usrp-users@lists.ettus.com
To unsubscribe send an email to usrp-users-le...@lists.ettus.com
