Dear, You can change the signal waveform (fro signal source) from sine to cosine.
On Fri, Nov 15, 2019 at 9:25 PM Ron Economos via USRP-users < usrp-users@lists.ettus.com> wrote: > You can't have a center frequency of 1 kHz in your UHD Sink block. The > frequency range of the B200 is 50 MHz to 6 GHz. > > If you change the center frequency to 50 MHz, you should see a 50.001 MHz > signal. > > Be sure to terminate the output of the B200 with 50 ohms. With Gain Type = > Normalized, Gain Value = 1 and Amplitude = 1 in the Signal Source, you'll > be transmitting at maximum power. > > Ron > On 11/15/19 00:44, Van-Dung PHAM via USRP-users wrote: > > Dear all, > > I am a newbie in this domain. I want to generate a cosine waveform in the > output of usrp-B200 (TX/RX). So I make it as the following picture > [image: image.png] > But what I got in the oscilloscope is not a cosine/sine waveform. I don't > know where I have a mistake. > > Thank you very much for your answers > > > > > _______________________________________________ > USRP-users mailing > listUSRP-users@lists.ettus.comhttp://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com > > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com >
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
