Hi Sam
Thanks for the information. My only doubt is about the FPGA. FPGA is
industrial grade or Commercial grade ? other parts I have verified and all the
parts are with Temp Range of -40 to +85.
As in case of B205mini it is clearly mentioned the grade of the FPGA.
Regards,Arun Verma
On Wednesday, October 16, 2019, 01:13:56 AM GMT+5:30, Sam Reiter
<[email protected]> wrote:
Hey Arun,
The temperature range for the X310 and the TwinRX is noted as 23 +/- 3 C. This
is meant to convey that the device is intended for indoor lab use and has not
been thoroughly tested in extreme environments like you've mentioned. You're
also correct that you'll see device performance change over that temperature
range and I think -20C will be dipping below the rating of some of the
components. Some key components can be found here:
https://kb.ettus.com/X300/X310#Key_Component_Datasheets
Depending on what you're hoping to do, we see folks develop custom enclosures
for these types of radios with and without thermal regulation. At the end of
the day if you're subjecting this radio to those kinds of extremes, it's up to
you to put it through its paces and make sure it'll meet your needs. I'll also
note that we don't formally endorse any X310 enclosures, but one of the few
IP67 OTS solutions I've found for the X310 is sold by Pixus:
http://www.pixustechnologies.com/products/enclosure-system-solutions/specialty-small-form-factor-rugged-x310-other-2/specialty-small-form-factor-rugged-x310-other/
Not sure if this does anything to extend temperature range, but it could be a
starting point in developing your own ruggedized solution to deploy. Also if
anyone else has recommendations or experience with X310 enclosure solutions,
I'd be curious to hear what you've made or worked with in the past.
Best,
Sam
On Sat, Sep 21, 2019 at 3:33 AM Arun kumar Verma via USRP-users
<[email protected]> wrote:
Hi Users
We would like to know whether X310 with TwinRx boards can be used for
temperature range -20 to +55 degree. Is temperature range is limited by the
components used in the boards or the performance is not guaranteed over this
range.
Are the components used are industrial grade or commercial grade?
Regards,Arun Verma
_______________________________________________
USRP-users mailing list
[email protected]
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
[email protected]
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
